2511 dialup routers port speed

[tuks]

hi,

Im employing two 2511 dial-up routers. Catering for 16 connection each. When I do a show line I often get this result:
SuvaDialUpRouter02#sho line
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns
0 CTY - - - - - 0 2 0/0
I 1 TTY 19200/19200 F inout - - - 0 0 0/0
I 2 TTY 19200/19200 F inout - - - 92 722 0/0
I 3 TTY 19200/19200 F inout - - - 0 0 0/0
I 4 TTY 19200/19200 F inout - - - 0 0 0/0
I 5 TTY 19200/19200 F inout - - - 0 0 0/0
I 6 TTY 19200/19200 F inout - - - 0 38 0/0
I 7 TTY 19200/19200 F inout - - - 70 117 0/0
I 8 TTY 19200/19200 F inout - - - 85 126 0/0
I 9 TTY 19200/19200 F inout - - - 91 604 0/0
I 10 TTY 19200/19200 F inout - - - 81 1087 0/0
I 11 TTY 19200/19200 F inout - - - 0 4556 0/0
A 12 TTY 19200/19200 F inout - - - 74 94 0/0
A 13 TTY 19200/19200 F inout - - - 84 2310 0/0
I 14 TTY 19200/19200 F inout - - - 0 0 0/0
I 15 TTY 19200/19200 F inout - - - 75 226 0/0
I 16 TTY 19200/19200 F inout - - - 0 0 0/0

The speed varies from 9600 to 19200. Im just wondering why couldnt the speed go up. We employing 28000 modems and all are set to auto speed. The line speed on the router is also set to auto. Below is the configuration.

line 1 16
autobaud
autoselect during-login
script dialer cisco-default
login authentication use-radius
modem InOut
transport input all
flowcontrol hardware

Users connect and they either connect on to a 19200 or 9600 speed. Need some advice.

regards

 

[BuckWeet]

Sounds like its your modems that are configured for that speed, not the Cisco telling the modems to work at that speed..


BuckWeet

 

[tuks]

I have set the configuration of the modems to run on auto speed

 

[wilsontec]

have you try use the command "rxspeed 115200" "txspeed 115200"

 

[tuks]

Where do i use that command ? Router or the modem ? By the way I havent used it yet.