2500 Cisco

[jaho]

Hi.
Strange, after I`v done write erase and then reload, console port doesn`t answer, tried once again wit aux, the same situation. ROuter doesn`t react on the break sequence. Don`t know how to get acces into it. there are 32 async ports, once connected only some few chracters appear at power recycling. I tried to change terminal settings, with no result.
Any help appreciated.
Thanks

Jaho.

 

[Auth]

try a manual break
1) setting the baud for the conencttion to 1200
2) powercycling the device
3) hold space down for 15 seconds
4) disconnect
5) set baud back to 9600 and connect

 

[JohnWhiteley]

not sure what emulator you are using, but the standard break sequence for cisco kit does not work on bog standard hyperterminal from NT, download the private version (not for works use unless you buy it of course)and it works fine.