i have a 2250 console that have all the leds next to the buttons on. i don't knwo why this happened but any help will be highly appreciated since we can't make work the console.
i'm sure you've unplugged it by now, that may help.. there is a maint command from the console for lamp test, but that usually times out.. i would disable both tn's then enable, could be the line card or the console itself
ld 20
prt
2250
to get the tn's of all consoles (i label mine with the tn on the number plate) (6 in service)..
i did what you said... but nothing changed... what about that test command? also, is there a way to run a diagnostic or something to test the 2250? some software or LD...
finally... if the 2250 is damaged we won't replace it with a new 2250 but a 2616 with keypad add on, what should i do to get this done?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.