Search results for query: *

Error 41 is usually a network issue Check the port speeds and duplex of the network card of the server. It must be set to 100/Full minimum not to auto negotiate. Also check the port and duplex speed of the switch It must also be set to 100/Full minimum not to auto negotiate. Check the DNS/Host...

You do not say what version of Arcserve you are using but Arcserve version 9 and before I have found that I could only get Arcserve to copy from tape to tape if the drives were on the same physical controller.

Answer to question 1 It is not possible to see Hardware compression ratio figures as far as I know Answer to question 2 Software compression should not be used at all for the obvious reasons, it is very slow and not that reliable Tapes are cheap these days so there is no need Compression...

[b-f]* does not work with Windoows This does work with UNIX so I am told Any other ideas Patrick

UNIX still has the edge over Windows since it is more tweakable, Veritas netbackup was written for UNIX and therefoe there is a lot more support from the UNIX stand point.

If the re-try time has passed then the make up job will not run. Set the re-try time to after the backup job will normally finish

Thanks for that Do you know how to backup the directories as specified or do I have to create a directory path for every letter of the alphabet and every number

I have a server with 700 directories I would like to back them up as follows NEW_STREAM Backup all directories begininng with the letter a NEW_STREAM Backup all directories begininng with the letter b-f NEW_STREAM Backup all directories begininng with the letter g-l NEW_STREAM Backup all...