Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Wanet Telecoms Ltd on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
3620 IOS Upgrade
maplesupport- Have you found an answer to this? I've got 2 IDENTICAL (hardware, memory, etc) 3640's with the exeception of their ROM bootstraps: ROM: System Bootstrap, Version 11.1(20)AA2 ROM: System Bootstrap, Version 11.1(19)AA They both have 32MB/128MB I cannot get the older rom version... -
Why ' Erase Flash ' Prompt When TFTPing File?
IPKONFIG and InDenial- Actually I used to tftp it right to the config - basically I had the drop and create statements in the file itself, but then if I made a typo in the statements I had already dropped the ACL from the interface so I was wide open until I reuploaded (that and the fact that... -
Why ' Erase Flash ' Prompt When TFTPing File?
When I update Access Control Lists, I upload the ACL in an ASCII file to the router via TFTP. For some reason when I upload the file it prompts me if I'd like to erase the flash before continuing and defaults to [confirm]. That sounds crazy to me! Why would it assume I want to delete all the... -
Module Question - NM-2FE2W vs. NM-16ESW
Thanks BuckWeet and sharkyj72- I was afraid of that and I did read that it was just L2 switching :( Unfortunately 10mb isn't enough in our setup, but I'm sure Cisco makes FastEthernet sub modules...(?). Ultimately I should use Cisco 3660 so I have more slots available or even go to a PIX... -
Module Question - NM-2FE2W vs. NM-16ESW
I have a module question - Hoping that someone knows a little about the differences: I have cisco 3640's that I'd like to use to separate subnets. I currently use dual FastEthernet module NM-2FE2W: NM-2FE2W 2 10/100 Ethernet 2 WAN Card Slot Network Module They work great - the problem is... -
3640 Line Modules Needed For my Setup - Advice?
All- I've got a pretty basic question. I've been running a 3640 Cisco with 4 T1 CSU/DSU modules for a number of years. We are now going to "up" our bandwidth and our provider is going to give us a single Ethernet handoff. So basically I can just "throw away" the T1 modules... -
Adding Additional CBlock to a 3640
I currently have a router using a single cblock from one of our providers. Our other provider just allocated us a new cblock. They are properly pointing the new cblock to us. I'd like to start using it... Situation: Provider A - CBlock1 (Currently Being Used) Provider B - CBlock2 (Not Being...
