Search results for query: *

mhoxie I have several systems on that release and have had the same issue with the Audit files (I Removed all but a few). The /var and root directories (df -h)were over 90%.In addition to the Audit files and Onex logs that were increasing the disk space I noticed that the catalina.out file was...

I too have had this issue (/dev/sda3 95%) with a Server Select IPO. I logged in via SSH via root and checked for any heavy disk usage (df -h). The following is what I found: /var/log/audit (worst culprit) /opt/Avaya/oneXportal/*/apache-tomcat/logs (as sizbut noted)...

Patch MPLR27326. Also,may see Bug365 when this problem occurs.

What's actuall causing the phone to say "enter value from 1-255" is the s2 action and/or s2 retry. Put the same values as s1 for s2 and you should be OK.

John, the problem follows the cpu as in the past we would simply login via the vt-520 (no switch a/b).I beleive the paddle board is installed in the network area of the backplan as we never had to toggle between active Cpu's.I'm scheduled to go to site tomorrow to trace or verify the cable to...

We have an Option 61C running Release 25, for no reason the TTY maintanence port (tty 1) is not accepting input from the terminal. It will output information from the PBX but will input "33333" when any key is pressed on the keyboard. I have replaced the keyboard (vt-520), reset the TTY port...

What is the recommended Backup method for the 0ption 11, LD 43 BKO or LD 143 Archive. The manual states that BKO is copied in raw form and does not organize the database backups. ARCHIVE, on the othe hand,allows databases to be stored and organized in seprate directories by name. Hence the...

Thanks John for the confirm and congrats on being the tip master of the week. Wayne

I have an Option 61C Rls 25 that uses the NT5D61AB IODUC cards. Had to power down the switch and after bringing the system back up noticed that the floppies were failing. To make a long story short I found Bulletin number: PAA 2003-351, which states the problem that I am having and the work...

I have an Option 61C Rls 25 that uses the NT5D61AB IODUC cards. Had to power down the switch and after bringing the system back up noticed that the floppies were failing. To make a long story short I found Bulletin number: PAA 2003-351, which states the problem that I am having and the work...

Certain CMDUs have floppy (FDK) issues. Try and reseat CMDU 1 (within 30 seconds). After you re-nable the card (enl switch and software) test the cmdu 1 again.

I've had this problem several times. Customers would call me and say that faxes were dropping but voice was fine. Of course, both were actually affected. However, the Fax being digital (G3) would drop and the voice you might hear clicking. I would dial into the switch and for the the Option 11...

I've had several PRI slip issues and each time the problem was with the carrier. Of course, I had to use my PRI analyzer to convience them that the problem was theirs and not mine as they kept implying. To the best of my knowledge the clock recovery circuit is on the T1 card. Make sure the clock...

Has anyone tryed CLID routing using the NAM 4.0 (Programming Caller ID using Feature 983,see page 108 Set Up and Opertaion guide). I have a MICS 5.0 with the NAM and the Caller ID is working great. My guestion is can you route based on partial CLIDS or do you have to enter the entire number. For...

I too, have had problems with new CI cards locking up lines where they display "line in use". When replaced or checked using ls/ds cards the problem went away. I had to disconnect the amphenol to reset the lines (faster than disabling/renabling. So am interested in what could be...

You need a patch from Nortel which will set the redirection on the Nam to no. Check back at the month of May as another subscriber had this problem and noted that he would email users the patch