YPSYES's solution works on cisco routers and would produce the desired results.
If you really want to go for the gold, try the following:
Telnet to the 3500.
Use file capture: Log Session to file
After logging in use the following:
Command: SH VER Find # of Mod’s in Switch
Command: SH...
Not knowing the 2950's current port configuration for the monitoring, let's try the following....
Configure the monitoring port with:
> spanning-tree portfast
If the port fails enter the following:
> show port monitor
> Post a copy of the response for show port monitor in your reply message...
My first response to a thread, hope I have it right....
> set ip directed-broadcast on each interface on the cisco router that has a 2950 switched ethernet hub.
To find out the interfaces use the
> show ip interface brief command.
Then you will go to each switched ethernet interface and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.