Recent content by TiggermanW

The main number will have have a DID number and have to be assigned to a target line as well. On a PRI, there is no need for hunt groups. The CO will send the call and the DID digits everytime, you can configure your nortel what to do with it from there.

Or from the phone, you can press Feature *0 then hit the intercom button to find the current extension/dn.

Hmmh, this worked before until they had a power outage. Yes, Dial mode is tone on the EM trunks on both sides. Answer mode DISA is no. I didnt think a straight T1 had target lines, only a PRI. Geesah, IIRC yes, you can upgrade to 4.1

T1 trunks on both sites are set to auto answer. Signaling is wink-start. TrunkType E&M. No Prim Set for the lines (001-024) both sites. My route (002) is set to use the POOL B which all lines are in. (same for each site) Setup access code 44 for POOL B. Dialing 44, then the extension, results in...

So if one wanted to maintain the Calling station ID between two systems, the only way is with a PRI and MCDN codes? Hmmh. Right now we have two buildings, a ptp T1 via microwave between them configured as E&M. The config one the one MICS got messed up and had to be redone. I can make calls from...

I found the solution. I'll configure an external hotline for that extension. Not sure how I missed this, but I did.

I just finished a phone system migration in the building here and have run into a small problem. The 3 elevators were on an analog port of the old (lucent) phone switch. The phone switch was configured such, that when the port was picked up, it autodialed the elevator emergency number. Is it...