Recent content by TDMtek

CS1k Rlse 7.6 I “may” need to take up to 4-Analog ports into some type of device, that I can connect to an Ethernet network. Then at 2 different locations drop out one Analog type phone and at the farthest location drop out two Analog Type phones, with one loud ringer attached to one of the...

Thanks, CP 1005r 5.0 I think i have figured out the solution. Still testing but so far it seem to be working fine on all the set.

Can I build a Mailbox of some type, that will not have a phone connected to it? And when it receives a new message, two deferent set will get the message indication?

Thanks

We are finally going to deploy a few 1140e IP sets at a remote site on our Avaya CS1Ke 7.6 system. If our end users were to press the Services key we want the sub-menu Diagnostic option to be password protected. Also when the end user presses the Services Key twice, we want that password...

The reports are between gateways. The reports are the same; the phone will ring, and then completely drop as soon as they pick up the handset to answer the call. But the very next call will complete just fine.

We have been on our CS1Ke 7.6 system for a little over a year now, and I occasionally get reports that internal calls will ring once or twice, and then drop. The internal party that was placing the call, has call back and then it works fine. I’ve had a few; a very few, over the last year say...

Thanks for the replies. I will try to change again later this week.

CS1k 7.6 system. I have one Media Gateway that has two groups of trunk cards; 6- UDT card in total. We will be removing the oldest set of trunk cards in the near future. Because of that, the LD-73 programming needs to be reprogrammed from the Primary CC on Card-1 to the New CC on Card-7. When I...

We currently have one MICB card installed into our 7.6, CS1ke system, with two DID-able numbers split between the available 32ports. I would like to add a third number. I have been able to free up 5 “channels” from the two existing Permanent Conf list, so that they can be assigned to the new...

We are installing AACC in the next few weeks and we told that our Telcorp reader board had to go away. AACC should/Does have a desktop client pop-up window to replace the reader boards. Or so we have been told.

My question is how are your PRI’s are set up; are they set up as a ISA master group with DID and DOD service routes, or Both Way Trunks. My guess at this moment is that the PBX and the PSTN is set up different. Have you been able to verify that they have set them up as they were; or is it just...

I first started this in the CallPilot Messaging area but received no responses, so i thought i would ask it here also. We have a CallPilot 5.0 1005R High Availability Voice Messaging system with the EMC Auto start software to monitor our Primary and Failover servers. We have started discussing...

We have a CallPilot 5.0 1005R High Availability Voice Messaging system with the EMC Auto start software to monitor our Primary and Failover servers. We have started discussing the removal of the Failover server, so that we are left with a Standard CallPilot 5.0 1005R server in place with VM, EM...

Anyone know of a app for the iPad/iPhone that will let me "dialup" a SEB that still has phone line access.