Recent content by tadiman

The clock controller card in responsible for deriving the clock off of the designated primary or secondary source (there isn't always a secondary) and keeping the system clock for pcm in sync with it. Since those two facilties are not taking errors they more than likely are not the source of...

Here's some thoughts. I feel the real problem is that not all of the PRI siganalling is being completed through the Cisco's. I would try adding the the command "direct-inward-dial" to the terminating router 'dial-peer voice 234 pots'. My guess is that the terminating router is...

Initially I would have to say the problem is the distance. While the same carrier has the traffic (obviously :) ) they may route through different pops after the traffic hits the initial frame switch. Since the transport network is frame relay, trace route won't do any good to distinguish a...

Where are these two brach offices? If one is the same town and the other is 3,000 miles and four or five carriers away then you will see a difference. If the users are seeing a difference than something is pounding traffic on it, broadcasts, misconfigured port, etc. You say that the two routers...

First get your mind off of a PBX. Start thinking a hybrid key system for that size. NEC, Panasonic, Comdial, etc. a lot more affordable, just as (if not more) reliable, less expensive to maintain, the list goes on and on.

Here's an interesting link. It's dated from October of 2000 but it might help you. http://www.sandman.com/opreview.txt

I had my own business a few years ago and used software called PhoneBiz. It was really slick and very affordable. The company name is Telintel and their number is 800-775-6030.(and I just called the number they are still in business). I used it when it was a DOS package. The windows version had...

Just an FYI here. Actually the DLCI's probably weren't backwards!! In your original post you stated that (mine is 200; remote is 100). When you program the dlci on the interface you tell it what is the other end that I'm to connect to. So the carrier was correct to say yours is 200, then your...

When you do a 'line vty ?' it is showing you the possible values that can be entered (command line help). The 'sh conf' confirms that only 5 are defined.

Layer 2 hasn't finished establishing. Your status shows "TEI_ASSIGNED" it need to be at "MULTIPLE_FRAME_ESTABLISHED". here is a sample of a BRI that is ready to place or receive calls: Layer 2 Status: TEI = 76, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED...

What your talking about is done frequently. There are several good reasons to do this. First these channels are "bonded" to make the bigger bandwith pipe. This pipe than can be used for internet, frame relay, ppp or just about anything depending on the equipment you install. A very...

Sounds like some form of authentication was programmed against the console port. Real world experience here, I did this to my self. There are several ways this could have happened. Can you telnet in via a serial or ethernet interface?

In the hyperterm properties, goto configure com port, under flow control try chaging that to none.

I'm not an Avaya tech either but I've had similar experiences with an issue similar. First, I have had AT&T tell me that they are sending ANI however that was because the tech looked up the order in the sales databease when he looked it up in the switch, guess what? The other issue I have had...