Recent content by soreldid

I think that it is done with this command: encapsulation dot1q 1 where 1 is the id of the VLAN in the switch i had configured both VLAN to go in the port where the router is connected. Thanks for your help. Didier

hi Degg, I tried trunking and no trunking, it didn't work. I don't know how to set the baystack interface in a vlan ! If you know how please tell me... Thanks for your reply Didier

Hi all, I am trying to configure VLAN on my Baystack 350 to be routed by my Cisco 2621 router. But i can't find the good parameters. The default VLAN is VLAN 1 on the Baystack so i configured it as encapsulation dot1q 1 native on my Cisco router. I only have one ethernet interface on my...

Hi all, I am trying to configure VLAN on my Baystack 350 to be routed by my Cisco 2621 router. But i can't find the good parameters. The default VLAN is VLAN 1 on the Baystack so i configured it as encapsulation dot1q 1 native on my Cisco router. I only have one ethernet interface on my...

Doing Static NAT or using route-map seem identical, is there any advantage in using route-map ? bye

In fact i was wrong because it Works. excuse me for disturbing. Do you know how i can do a configuration example with this conf and where i have to put it ? If you see any mistake, or a better way to do something may you tell it please. Thanks. Bye

Right know i achieve both dynamic NAT working with this configuration: version 12.2 no service pad service timestamps debug uptime service timestamps log uptime service password-encryption ! hostname test ! enable password 7 0016040016 ! memory-size iomem 25 ip subnet-zero no ip source-route ...

Hi, I wish to do dynamic NAT on a serial interface and on a FastEthernet interface and static only through serial interface. I set up a test platform but i can't achieve this configuration. Any suggestion or help welcome. Didier Sorel