Recent content by soasol

Installs fine however when I launch the application on a specific users machine, I don't get a splash screen. The icon appears int the system tray and program trays but nothing else happens. No splash screen, no app gui, no messages, no nothing. Have to kill the application via Task Manager...

The protocol version refers to whether the circuit is configured for AT&T custom (a) or NI2 (b). Your service provider should be able to tell you which one they are using. Best practice is to make sure that the wiring is good by placing a loopback towards them at the last possible point. If...

It depends on how you program the station as well. Type=6408D+ you get Speakerphone: 2-way However if Type = 6408 you get Speakerphone: 1-way Hope that helps.

It's actually a trunk to a conferencing system. We have the DID extension routed to a single trunk group with two DS1's. We are using aar to the route pattern which has the trunk group in it. So dial x1234 when on network or call 999-999-1234 from a cell and get to the same route pattern...

After reading my post again, I realized that I didn't explain it all that well. Sorry about that. These are all incoming calls to the same number that route to the same trunk group. Let's say I call x90000 from my cell phone, it will route to the 2nd ds1. If I call x90000 from my desk phone...

I have a G3R with R11. Whenever I call a certain trunk from the PSTN I am routed to the 2nd DS1 in the group, whereas when I dial from inside I am routed to the first DS1 in the trunk group. Any ideas as to why dialing the same trunk would make an outside call skip an entire ds1. I have not...