Recent content by shandy11

Dear AramHowe, Thanks a lot for your help. The system is up and running.

Hi Aramhowe, Thanks for the reply. Do you have the configuration notes for G350 ip route config that I can verify with my current settings?

Hi expert please assist. I have a S8300-G700 (Site A)and a remote gateway G350 (Site B) with CM 3. When I call from site A using IP Phones to TDM extensions, no problem. I have the trace like below ___________________________________________________________ 19:12:44 dial 500 19:12:44 ring...

Get a combo patch from Avaya to recognize the usb. Should work.

I have synchronization cofigured on the ch sync.

Hi there, I have a problem on CM 2.2 for fax lines. When incoming fax from ISDN DDI, to the fax machines in the PABX, it refuses to talk with the machines and intermitten the faxes go through but most of the time it won't. I have tried to troubleshooting the ISDN, but the service provider said...

Anybody has any idea where can I get the bcms R1 software in the internet? Thanks.

Hi all, I have used a 128MB translation to backup data from a 8700. I backup the xln/os/security tar.gz files into the card. When I restore the 3 gz files to the new 8700, the license and config of the servers are able to go through but only all the translation are empty. Meaning no...

Hi Joe, The integration is IP and I have used the H.323 integration manual from Avaya but seems like the problem is hidden somewhere. I am using a S8700 pabx CM 2.2 RTMCKEE, Nope. It didn't work. Thanks anyway.

I have a modular messaging installed recently on ver 2.0 There is a problem that the voice messaging. Whenever user dial the pilot number of the MM it will not prompt the "text to speech on the user name" but rather prompt user to key in the user's mailbox instead. There must be some...

I have a S8710 (main) and the LSP (G700 with 8300) is not working although the is gateway is already registered to the c-lan in the S8710. It only work as if a remote gateway but the LSP is still out of service. The RFA has LSP RTU on and I have rebooted the G700 after all the config. Please...

Hi Jaymaster, Thanks for you info. Rather useful. I found that my led fiber sync is not there but the rest is on. (server 1 Tx and server rx) Both led for Active link is up but sync led is out. Could it be the fiber module faulty?

I have currently installed a S8710 and everything is fine except the shadowing of the system is down. I have trying using a new cross connect and a new fiber cable. It is still down and it doesn't refresh its standby processor. In the alarm screen, the system says "Can't open Duplication Card"...

It is a matter of restriction from the exchange. The Caller ID is sent to the ISDN pipe but will only show the directory number.

Will try that out. Thanks.