Recent content by sd0948

Thanks for the idea.

Yep, all SIP. NO H-323

I have a new Avaya Aura (6.3) fully SIP system and need to create DNs that I can route to VM. In a CS1k I would build a phantom DN and dcfw to VM. In an Avaya Aura (TDM) I would build an X-port with a coverage path to VM. In the SIP system, thru the System MGR page I tried building a vector and...

I have asked the same question. I have learned how this feature works (weird). While on an active call if you press the button the caller is sent to your mailbox...??? This is the response I have been given so far: One X or any other SIP phone PROBLEM CLARIFICATION On logging into softphone...

Does anyone know why our 9641 SIP phones will boot up and go into service and the 9611 SIP phones will not? The 9611 will go into service h-323, but when we change it to SIP it restarts, boots up, but never makes it into service. The display shows "acquiring service".

brand new.

problem resolved. It was bad hardware. PRI card.

Hey Smokinjoe. PRI works great on the Option 11. Smart Jack is good. ESS5 is the interface of the Option 11 trunk route and D-Channel (IFC prompt) because our serving CO was configured that way back when this was originally installed. Thanks

Hey Smokinjoe and VZtech, that's what we have. We were able to get the carrier to test with us last night and do a temp change to NI2 but we still had the problem. We are awaiting the arrival of a new PRI card/daughter board to test with today. Thanks for all of the interest from you and vztech.

straight ISDN PRI from smart jack to IPO. have dual PRI card and tried both ports. Same problem. Also changed config to try ESS4 with same results. Beginning to think the IPO 9.03 is not compatible with ESS5.

IPO can hear, external caller cannot hear, whether inbound our outbound. Sets are 9508.

Yeah, we tried NI2 and could not even initiate a call. The PRI would not float up in the IPO. Thus, the ESS5 setup is correct from my view.

we are cutting over an IP office from a Nortel Option 11, just moving the existing PRI which is formatted ESS5. Results in one way transmission on inbound and outbound calls. PRI shows "In Service". Any suggestions?

Thanks Kyle555. I found the 46xxx file and will work with that. Also found that by programming something on all keys there still remains only 2 pages (phone page and feature page). To access the full list of programmed keys on the feature page you must navigate down rather than to another page.

This is my first exposure to the Avaya 9608/9611 sets. I can only see 2 pages of line/feature keys on the phone while I see 24 programmable buttons in CM. Also, a feature programmed on button 5 actually appears on button 9. It looks like all line appearances show on "page 1" and all feature...