Recent content by ronmis

That's what I was afraid of. Thank you everyone for your input.

I need to get the controller installed because I cannot get it to boot in the first place. As it is going through the boot process it will error out with a no root controller error. The hard drive was setup on a different controller and I had to switch to the 29160. That is why I need to load...

Normally I like the 29160, I have had very good luck with them as they rarely malfunction. I normally connect one hard drive, a tape drive, and a CD-ROM. Thanks for the link I am going to check it out.

Is there a way to get that to look to the floppy? It will only look at the hard drive and is not even looking at the floppy.

Thank you I will try that.

That would work, but I don't have another SCO box.

What is the best way to configure a parallel port at the command prompt?

I need to pull data off of a hard drive and don't have the original configuration of the system it was designed for. I have a similar system but the SCSI controller is not the same. I need to make the hard drive recognize the controller so it will finish the boot process. Any suggestions? I...

I tried looking at man custom but it's not acting right either. I have a feeling I will be re-installing to correct this problem. Unless there are anymore suggestions.

yes.

When I issue the mkdev lp the manager screen flashes and I see a message that says, "unable to get allowed/denied form" Has anyone ever seen this or know the solution for this? I would appreciate any help that is given.