Hi!
Thanks for your attention. I realize that only manufacturers can do remapping. It's bad news.
Thanks again Any of my advices based on the my understanding of facts you supply.
Excuse my English, I'm from Russia...
Hi!
What chipset used on mainboards that you try?
I have some problems of this kind with VIA693 chipset mainboards with TNT2/TNT2 Vanta.
Did you install the latest drivers for mainboard? Any of my advices based on the my understanding of facts you supply.
Excuse my English, I'm from Russia...
Hi!
I mean to make invisible some physically damaged disk areas.
Sometimes we send drives with damaged sectors to vendor (for example, Western Digital), and after time this drives returns without bad sectors, but it size slightly decreases. I try to find a way to do such repair in my lab, so I...
Hi!
Try to assign another IRQ for your printer port/modem, then if your ports work fine, try to troubleshoot your sound card again, or also change its IRQ manually.
Any of my advices based on the my understanding of facts you supply.
Excuse my English, I'm from Russia...
Sorry, you misunderstood me. Then I say "clear this blocks", I mean - make it invisible. The scandisk and chkdsk only marks blocks as bad, so operating system can't use it. But I want this blocks invisible. It can be done, I assume in HDD controller/HDD BIOS level - write this bad...
Hi!
I have some HDD with lots of bad blocks. I know, that there are some programs that allow to clear this blocks from drive. But I don't know there can I find the one of this programs. Can anyone help me? Any of my advices based on the my understanding of facts you supply.
Excuse my English...
Hi!
The PC-Chips mainboards are jumperless so there are no jumpers or switches on board and all CPU parameters controlled via BIOS Setup.
It's normally, that your system is unstable after overclocking. Some CPU chips don't support overclock. You may try to slightly raise the CPU voltage, but...
Hi!
Yes it would increase the amount of RAM installed on your computer. But sometimes two banks of RAM may not work together correctly. This usually depends of RAM chips type Any of my advices based on the my understanding of facts you supply.
Excuse my English, I'm from Russia...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.