Recent content by petermit01

Ok, thanks for your help. Take care. Peter

Hi lui3, Thanks for your help! The configuration is routing Internet traffic. However, it doesn't seem to be working as fast as my old linksys router. Sometimes it takes up to ten seconds to open a webpage or will time out. I'm not sure if there is something I can do with the configuration to...

Hi lui3, Thanks for your help! The configuration is routing Internet traffic. However, it doesn't seem to be working as fast as my old linksys router. Sometimes it takes up to ten seconds to open a webpage or will time out. I'm not sure if there is something I can do with the configuration to...

IT'S WORKING! Here is the running-config: sh run Building configuration... Current configuration : 1277 bytes ! version 12.3 service timestamps debug uptime service timestamps log uptime service password-encryption ! hostname Cisco1720 ! boot-start-marker boot-end-marker ! enable secret 5...

I made the change. Still no success. Here is the new config: sh run Building configuration... Current configuration : 1256 bytes ! version 12.3 service timestamps debug uptime service timestamps log uptime service password-encryption ! hostname Cisco1720 ! boot-start-marker boot-end-marker ...

I changed the ip route to eth0 and removed the dialer. Still experiencing same problem (see beginning thread). Here is new config: sh run Building configuration... Current configuration : 1388 bytes ! version 12.3 service timestamps debug uptime service timestamps log uptime no service...

No, I don't think a dialer is required. I'll try your suggestion, thx.

Hi, I've poured over many threads trying to find one that contains the solution to my problem. No luck yet :( I am configuring a new 1720 router. The internal LAN (192.168.x.x) is working fine. The router has a WIC-1enet (ethernet 0) being used to connect to the cable modem from ISP...