Recent content by PeterMarcus

I just put DISA on to see if it would work and rule out a line config problem....at least it's coming into the Nortel. Normally, I have the lines in manual answer mode and DISA isn't even an option. When I tried DISA, I got the dialtone, but that was just a test. In normal manual answer...

It's E&M, with DID turned off. They're basically individual lines, in one trunk/hunt group. Each inbound call starts at line one, then rolls over if that's busy, etc...

I have a MICS 6.1, T1, Call Pilot 100. AA on and configured. When outside lines 1 and 2 call in, they ring the receptionist for 3 rings, then go to auto attendent. For outside lines 3 and up, when a caller happens to call in on one of these lines, they get a fast busy. In the AA setup menu...

Uhhh, that would be the easy answer I guess. Because I started with the 100/102 initial mailboxes and figured the numbering scheme followed through the 100s. Never mind...I'll reprogram from the DN list on up and then try to scrub the "stupid question" stamp off my forehead ;)

I figure there's gotta be an easy answer...or it's impossible ;) When calling in remotely for messages on a newly installed MICS/CP100 system I programmed, the user presses "**" and is asked for their mailbox number and password. Is there any way they can enter their DN and password instead...