Recent content by partnerman

Have you tried putting an MVP130 on each side.Set MVP faxing to T38 and make sure fax is set to 14400

It is an analog port from the module

OK I'm probably missing something stupid. Coming from a Partner System Customer has Night Bell and overhead paging IP 500 can use either a station or trunk port connecting to a page pal (I have a UPAM if needed) I can get Paging to work but not the night ringer.If I unplug from the Page port...

Thanks.Thats what we thought.

I have a customer that has a BCM50 with analog trunks.They want to use 8 DIOD lines with 40 DID's.Is this even possible? I would think we need to go to a PRI. Thanks

What I'm looking for kinda looks like a 4x4 sticking up out of the ground with a weather proof cover over it

Looking for an outdoor termination point and can't seem to find.The style I'm looking for is sticks out the ground app 3ft,maybe 4x4 with a plastic cover.Inside is screw style terminations.Will be using icky pic. I have seen these in residential areas,golf courses.They are usually gray in...

I have the same issue.Upgraded to a Magix processor.Using the Intuity PC I click on Switch Administration and the box comes up blank.I had them check to make sure the admin port was plugged in.Any suggestions?

I have a customer that needs to dial International(they are in US).They just got a new PRI with AT&T.When they would dial out they would get a busy.I can see it grab a Line.Have the ARS short code as 011N; Nuber 0N Dial. The tech from AT&T states that they want us to strip the 011,So I did (user...

I have a 406 3.2.57.This is the last site of 4 networked together.Each site has their own conference meet me's.The 3 sites prior to this I set up *551,*552 so on for the conference,a few I pointed a DID to for dial in.All work fine.This last site is giving me trouble.Set up the shortcode the...

Thanks Tom you've been a big help as always Last night I checked the Cover Delay and that was the ticket. Thanks again Mike

Tom, 791 is assigned as AA1 hopes this helps Thanks Mike

Thanks Tom, I just got into voicemail and checked the AA.Only AA1 is used with a day and night messages (console has night button) Their are no lines assigned to AA.When I call in the AA does pick up after 6 rings. Any Ideas Thanks Mike

I am working on a Merlin with CKE5 Processor.I've tried the standard procedures that I have found in the forums,but no luck. Trying to change rings before going to AA(from about 6 to 3).I wasn't sure what Extension was for the AA (791,772)so I printed Group calling and changed time based...

Just Added a 412 card to our phone system,Did a board renumber.See's the card but voicemail will not pick up.Even by dialing the port extensions cke5 412 tdl 800 gs/ls 800 did merlin messaging 412 tdl (new one just installed)