Recent content by Nunezy

Hi all, I have a massive problem, and one is that I know nothing about W2K server and Exchange 6.0. My problem starts with a NT4.0 server running Exchange 5.5. My PDC also runs NT4.0. How do I copy my mail boxes from the NT4.0 server running Exchange 5.5 to my new W2k server running Exchange...

Hi all, If somebody could help me with an issue. I am trying to move mail boxes and all setup configuration on our exchange server which is running on an NT4.0 server to a new server running Windows 2000 server. I need to move the mail boxes and the .edb files etc. I do not have a backup unit...

Thanks for your replies. if I run the -remove or sc commands I get the message "The name specified is not recognised as an internal or external command operable program or batch file. I am running arc serve 2000 Group/Special Edition. I un-installed the program as by Arc Serve support...

I have a small problem that I need to overcome. I want to remove a service from system services. the service I am trying to remove is an arcserve service called "Arcserve Discovery Service". This is because I am trying to install Arc Serve 2000 under NT4.0. When the program is...

Just want to add that I want to start the arcserve discovery service and it isnºt allowing me to. I do not want to disable and I have tried to set to manual but nothing.....

Hi all, I have a small problem that I need to overcome. I want to remove a service from system services. the service I am trying to remove is an arcserve service called "Arcserve Discovery Service". This is because I am trying to install Arc Serve 2000 under NT4.0. When the program...

Once again thanks for the response. You are right on to say that the port is on 25. From our network I can telnet to 195.23.58.42 on port 25. This must be a block from the outside world from what you said in regards to the ISP blocking the ICMP traffic. Problem is getting it through the ISP...

One more thing that I remembered. When people email in to us, not all the time, but sometimes they receive the message "mail could not be delivered" It is one of those typical router mail messages when you type in an incorrect address. Could this be a addressing issue, again bringing...

Thanks for your reply again, I should give you some more background info. What seems to happen is that sending out is no problem. Receiving from the outside world is. We do have a router, but sure on the firewall side. I believe the firewall only exists on the ISP provider in who we leased...

Thankyou for replying, our domain is latitudes.pt. Sorry as Exchange is new to me so I have been thrown in the deep end to help out. I don´t think we have a fixed IP either as when I put in www.latitudes.pt i get no display of an IP address. Once again I want to thankyou for your help on...

Hello all, I have a problem in Exchange 5.5 where I all users can send mail in house and receive mail inhouse. Mail that is sent out on the internet works to but we cannot receive mail. I know of this problem usually relating to DNS but hour DNS seems to be fine as been told by the ISP...