Recent content by norman77

no, you could probably keep data services off and use the device for voice/sms. When you turn data services on then the messages will be downloaded.

It seems like there is no comm happening thru the serial port. Since I don't have an adapter to convert 25 pin female to 9 pin female I am using Female 25/Male 9pin adapter with female/female serial cable. Could someone confirm if such configuration should work? Thanks

Connecting to PBX with terminal em. s/w. When I connect to the PBX with terminal s/w on my PC it doesn't communicate. Dumb terminal communicates fine on the same connector. Terminal s/w used: Hyperterminal or Procomm 2.11 on Windows XP. Tried connecting with various terminal emulations: ATT...

Could anyone give me info on setting up NCOS to restrict international calls only on Options 61C, Succession 4. Thanks

Thanks again: Are there any distance limitations? Also, could someone refer me to a document that would have a diagram of the cross-connects. So far it's clear to me that: Blue pair is the primary TN Orange pair is the secondary TN I am not sure which pairs are for power TNs, battery or...

Thanks John, In the location where the console is going to be placed I will need to re-terminate the console cable. Could you tell me which color cables that are terminated on the D-type console connector should be terminated to the Primary, Backup and Power TNs. Thanks again.

Hi: I am planning to move a 2250 console from one location to another. I know the primary TN and the back up as well as the 2 power TNs. However, the cable form the console has 6 pairs terminated in the bix block. I am not sure if the other 2 pairs are redundant. Does anyone have a mapping of...

Thanks Hawks, I got it. My previous reply was to wdlhb comment

However, it's not a wireless set. It's an analog set with a display. Why would it do that?

Could someone explain why do I get error SCH6405 when I try to change CLS to CNDA on 500 set (M1 61C). The system wants me to make the set wireless. ??? Thanks.

Thanks to everyone, So far I tried setting FBD, however it gives busy signal to external callers if the ext is in use. I can't set HBTD because we don't have package 131 installed. Also, this extension appears only on this set.

Could you let me know why? Seems like "Forward on Busy for DID calls" should be allowed to forward it to Voice Mail. Thanks.

Thanks everyone for looking into it. Here is the printout: (correction: the DID# I have problem with is on Key 2 not 3, as I mentioned before. TYPE 2008 CDEN 8D CUST 0 FDN 3800 TGAR 1 NCOS 4 RNPG 0 SCI 0 SSU LNRS 16 XLST CLS CTD FBA WTA LPR MTD FNA HTA...

CFTA is turned on as well.

this is a bit tricky. The primary DN has a secondary ext# so the LHK key is set to 1. The DN I have problem with is on key # 3.