Recent content by miketanaka

Thanks, for such a simple solution, for some reason manager was at 6.15.

After uprgading a 412 to 4.2 from 4.0 manager cannot find the control unit although Sys Moniter can connect to it. Any suggestions?

I am trying to create the correct short codes for incoming calls to a videoconferencing system connected to the first 4 ports of a S08. I created an incoming call route as follows: Incoming Number 5220 Desctination 555 Bearer Any I created the following shortcode: SC 555 TN 5220 Line Group...

I am new to IP Office coming from Nortel Options. I am trying to create multiple appearances of virtual extentions from the DNIS digits passed from a PRI trunk which can be picked up by users having those appearances without automatically answering and busying out the extention. Is there any way...

No not the mini cabinet but a thing called the compact which has special trunk and line cards. I am wondering if the base cabinet can be expanded to a standard size Option 11 cabinet.

Yes, so have I but, the problem is that to my knowledge they are not supported on the Option IIC compact, or am I incorrect?

The connection to the PSTN would be over PRI but I need to breakout BRI connections for videoconferencing. I know PRI is supported on the compact but I am not sure if thre are BRI cards for it.

Can anyone tell me if it is possible to support ISDN BRI station ports from an option 11C Compact with ISDN PRI? IS the only way to network an 11C Compact with an Option 11 with the BRI card?

I have a Magix R4 system and I have a BRI trunk properly configured. I want to use a videoconferencing system on a MLX adjunct port programmed for 2B Data. How do I determine the DN and SPID for this port and how do I configure it to use a shared BRI trunk for incoming and outgoing calls?

It appears that what I did was to assign a non messaging dn as a group member which then prevented me from selecting IntegratedVM from the group type. I just deleted all the members and started again after inspecting members and this solved the problem. Thanks all for your assistance.

Thanks a lot that did it.

I am new to Merlin (working with Meridian One only) I am trying to program a T/R station for a fax on a 016 TRR card on a Merlin R4 system and I cannot get it to direct a ISDN BRI DN to ring on the fax line. ALl lines seem to ring on the fax line. I have programmed the line for only the one...

I also find that when doing the system proigramming for the Messaging Card, after completing almost all steps when I get to Extentions-Group Calling-Group Type and I select Integ VMI it will not allow me to enter it giving me an error tone.

I have a Magix R4 System with a Messaging R1.1 and although the WinSPM inventory shows a messaging card in slot 5. In System Programming Config Merlin Messaging it states no merlin messaging board present. Any ideas?

This is exactlywhat I did. I am thinking there might be some problem with the Telco provisioning as I cannot understand why there would be no incoming ring.