Recent content by mickaloha

ARS ROUTE CHOSEN REPORT Location: 1 Partitioned Group Number: 1 Dialed Total Route Call Node String Min Max Pattern Type Number Location 1 11 11 13 fnpa 1

disp ars ana 1253 Location: all Percent Full: 1 Dialed Total Route Call Node ANI String Min Max Pattern Type Num Reqd 1268 10 23 deny intl n 1345...

S8700 running CM 4.0.4 and the card is an old 464F.

TG3 is a wink/wink. The actual LD line is a tie trunk, not a PRI. Listed below is route pattern 13 along with the first page of trunk group 3. Pattern Number: 13 Pattern Name: TN 1 - LD SCCAN? n Secure SIP? n Grp FRL NPA Pfx Hop Toll No. Inserted...

Partition routing tables are empty, so nothing is holding it up there. I even put the number into ars ana loc 1 and I still get the busy signal. Can it be something on the PRI preventing the call? If so, I will give AT&T a call up and see what they can do .

I am dialing from the 650 area code. I am referring to 91253242. When I dial other numbers long distance, it doesn't truncate it like it does for that area code. I dialed redial via the phone so I don;t think it is a slow input. I will check partition routing.

I have a problem dialing to the 253 area code from one of my locations. The other locations can call this number. My main location cannot. It drops the last three numbers and gives a busy signal. I cannot figure out why. Listed below is the trace I performed. :59:27 xoip: fax:PT modem:PT...

Thank you mwarren. We have it set up to be a 30 seocnd service level. Is there a way to measure just the service level or is that through the vdn report? My people need to know if they should adjust the service level to account for the announcment. I told them if shouldn't matter since I am not...

I am wondering if the announcement playing is figured into time it takes to answer a call and how it affects the service level. Example would be I want a service level of 30 seconds. If the announcement plays for 10 seconds, do I need to make the service level 40 seconds if I want a 30 second...

I see many people are contributing to this subject. Thank you for all of the information. Basically I am with Toni269 as long as the pay is good I could care less. I love information and that is why I come here. This is the best Avaya board that I am aware exist. Keep up the good work you guys.

Thank you for all of your answers. Systems administrator it is then.

I am a systems administrator who also supports our PBX and I am trying to find a job title that incorporates both of my primary functions at work. Looking on the web doesn't yield much information though so I came to the source. I thought about converged telecom engineer but I was thinking that...

I am using the the motorola t721 and other people here use the 7280 blackberry all by AT&T wireless. I had my phone set to loud and long but it did not work for me. I will look for the key sounds that you mentioned. Thank you for all of your help.

Do you mean on the cell phone? Where would that be listed or is this something on the switch?

I have set up a meet me conference vdn with great success except one problem area. AT&T Wireless gsm phones. For some reason the switch will not recognize the tone or lack thereof of the gsm phone. It recognizes call from tdma and cdma cell phones though. It recognizes call from pots lines as...