Recent content by mccleanbavx

i have 8 switches connected to AVAYA ASA software all over ip. two are connected with ssh enabled , I have a problem with one of these two , I can get connected sucessfully but when I type some commands like list trunk or try to change trunk, the system hangs, I need to disconnect and reconnect...

I was away for a few days I will try this tonight and let you know , thanks

I have an s8300 media server with voice mail. I have 2 reception extenions in a hunt group . Currently the incoming trunk goes to extension 790 with routes to aa in the voice mail, I want to program the incoming trunk to go to the hunt group for reception then if eith busy or not answered go...

I have a g3si with an auto attendant. I have 2 main reception extensions 6416d+ ext 700 and 720 At the minute the incoming trunk goes to the auto attendant 790 works fine. I now want the incoming trunk to go to hunt group with the 2 main boards first then the auto attendant I have tried...

I have an old AT&T 4.5 kva ups model 6 / s044601A1D2AE00 I am looking for a manual for this can anyone help..

I have a fautly c364 t pwr ethernet switch which will runs the power supply fans , but no lights or operation any ideas would be greatly appreciated......

i have just got the hold of a kirk dect system. i have connected it to 10 analogue ports on my g3si. I need to be able to make the analogue extension ring at the same time as the desk digital extension, so that when the user is away from the desk , they can answer . i could use call forward...

I have a c364t-pwr ethernet switch which has a fault of when the unit is turned on from cold it runs fine, but when the unit is powered down it takes 3 hours before it will run again when power is restored. Any help on this would e great..

I have a problem when I use an ip softphone on our pbx to call an external del line the person at the other end hears there own voice ( an echo ) . I have tried various settings and also usb handsets with no luck ... any help would be most useful.....

By the incoming call number I mean the call line id not the number dialled to get into the switch... eg if i use a mobile to call the switch I want to examine the mobile callers number and route the calll differently for different incoming mobile numbers..

is there any way for an s8300 to examine the incoming call number and direct calls from certain incoming numbers to a set extension

Knoester, I am writing with regards to a post you submitted apil 06 you had a problem where a first line coinnected was disconnected when a second call came in denial event 1191 did you solve this, I have the same issue and cannot find the cause, thanks

Try downloading the latest version from the AVAYA support web site. I had a similar problem with a softconsole. good luck

What I am checking for on the ip-codec page 2 screen ...

I get dial tone ok and can dial out no problems using a normal analog phone. the system is set up with a 9 and using the call logger the call is attempting to go out. i get a line busy from the visa machine