Recent content by MarcusInDallas

It loks like the ip address should work. Cisco is using IOS version 12.3 and it never hurts to upgrade unless your equipment/components doesn't support the new IOS. Try the command "sh run" and see if you have an ip address for the ethernet card already in use. Or try another ip address.

I have a Cisco 2610xm Router trying to connect to SBC via DSL using ATM. The router successfully connects to their router (maybe “successfully” is the wrong word) and the PVC are correct. However, when I ping the gateway I receive an encapsulation error from the ATM and sub ATM. I keep...

Thanks for everyone's help. I sent the router back to Cisco and received a new one which works right!

I have tried on two seperate computers. A laptop with a single nic and a desktop with dual nics. Both masks were changed at the same time. I am using a crossover cable when directly connected to the router.

Ethernet adapter Local Area Connection: Connection-specific DNS Suffix . : sbcglobal.net Description . . . . . . . . . . . : Broadcom NetXtreme Gigabit Ethernet Physical Address. . . . . . . . . : 00-10-18-0B-04-38 Dhcp Enabled. . . . . . . . . . . : Yes...

Right, but if I'm just trying to talk to the router it shouldn't matter at this time, right? On my other nic I do have a gateway to the internet

I just changed all the ip addresses to have the subnet mask to 255.255.0.0 to fit the 172.25.1.47 of the router and 172.25.1.69 for the computer Nothing new has happened

2600#sh tech-support ------------------ show version ------------------ Cisco Internetwork Operating System Software IOS (tm) C2600 Software (C2600-ADVIPSERVICESK9-M), Version 12.3(9), RELEASE SOFTWARE (fc2) Copyright (c) 1986-2004 by cisco Systems, Inc. Compiled Fri 14-May-04 14:37 by dchih...

-Computer is connected directly to fast-ethernet router -Tech-support is coming =========================================================================== Interface List 0x1 ........................... MS TCP Loopback interface 0x1d0003 ...00 0c f1 e5 b7 d6 ...... Intel(R) PRO/100 VE Network...

All other NICs are set to disable

>route print =========================================================================== Interface List 0x1 ........................... MS TCP Loopback interface 0x1c0002 ...00 0c f1 e5 b7 d6 ...... Intel(R) PRO/100 VE Network Connection - Pa cket Scheduler Miniport...

2600#sh ip route Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2 i -...

There are no control lists setup and then I am switching back and forth from router to pc and router to switch to pc. currently -Pc connected to router -both full duplex speed 100 -subnet mask 255.255.255.0 -router can see mac address and ip address of pc

Can't telnet to the router either

the ip 192.168.1.245 is really 192.168.1.254 -- typo when I hooked the router to the switch it found another router with ip address, 192.168.1.254 and told me there was a duplicate ip address on the network. So I know the fa0/0 port is making a connection and can see other machines on the...