Recent content by kelsjon3

I do know that Windstream is an approved SIP trunk provider. http://marketingtools.avaya.com/knowledgebase/businesspartner/ipoffice/mergedProjects/manuals/appnotes/WindstreamIPO7.pdf?zoom_highlight=windstream#search= "windstream

HP ProLiant DL120 G7 Quad-Core 8GB RAM Recordings work fine, system resources are good, just no browser access outside the server. :-(

But...... http://www.tek-tips.com/viewthread.cfm?qid=1613628

IP500v2, all latest 7.0 Q3 versions. We have CCR, vmpro, and ContactStore on a single server. 2008 64bit. We can access the browser interface from within the server using http://192.168.1.200:8888. If we attempt to access it from any workstation on the LAN, it times out. We've tried using...

I know this is an old thread, but I wanted to revive it. We're dealing with the same issue. We are asking the customer to extend their communication tools to their PC's. An IM client without notification of an incoming message is, at best, of limited value. Someone please tell me I'm...

I did a bad job on that post....... We were trying to login to vmpro (IP Office Application Server 7.0.10.2) using the vmpro client. Someone entered the wrong password too many times. We had not created any additional administrator accounts. Subsequent login attempts gave us a "The User is...

We have a new installation with the Appliance Server. We are trying to log in as administrator in the client. Using 'Administrator' and 'Administrator' it tells us "The User is Blocked". We have waited over an hour, no luck. Tried changing the time via the web control, again no luck. Please...

Just to share our experience: We installed a new v2 in Partner mode with 1408's and 1416's. All sets had low speaker volume and an overbearing, consistent "reverberation" on every outside call. We installed 6.0.1803, which fixed the speaker volume on all phones, but the reverb only on the...

We had this exact problem. After much troubleshooting, a new v2 fixed it.

Please be aware that the 6.1.5 Administration should be downloaded........" Just installed a 6.1.6 yesterday. Soon to be a 5-site SCN. oops. Should I go back and put on 6.1.5?

Thanks for the reply. AT&T sent out a tech, but unfortunately I was not there to witness the testing. He reported the circuit clean. I have changed out the cable from the smart jack to the PRI card, which is only about 12' long. I have gotten zero alarms in System Status. I tried changing...

We have a customer experiencing one-way audio on incoming calls. They can hear the caller, but the caller can't hear them, at all. It happens at least a few times everyday to various users. They have: IP500v1 6.0(8) VCM32 w/ PRI daughter card Phone8 2 IP400 DS30 modules (PCS 5 or greater)...

http://www.tek-tips.com/viewthread.cfm?qid=1060585&page=5

I don't know the maximum length, but if you decide to go ahead with this I'll be glad to share what I can remember. TechTip on the subject: http://marketingtools.avaya.com/knowledgebase/businesspartner/ipoffice/mergedProjects/bulletins/techtips/134_techtip.htm Also, we created mailboxes in...

We did this using PRI cards with the two systems sided by side. If you have at least two copper pairs between sites, or you plan on using IP sets across the fiber, this would certainly be an option.