Recent content by keith101

It looks like your MSW thinks its the final relay for mail. You need to check your SMTP Relay, Routing entries. I have confirmed that I can make my system behave like yours by removing an entry in my Routing. You need to have a forced rout with your domain as the mask and an additional route...

Also in mine, I see by the log file, that there are two x RCPT TO: in the same SMTP connection. I take it you only see one RCPT TO:

So if the send two emails to the same domain you will get two msg in holding? I only get one msg. I will check how my system sends it out it

This is how smtp email works i think?. You could check the email from exchange to MSW but not the outgoing one.

I would say you needed the 3rd party tool called the "re-processor" to do this one because you are combining two rules with AND, I think this is not normally possible. I am guessing that this tool can handle this one.

I think you will need another smtp server to do it. I have seen people talking about sending mail based on the senario rules to another server. They use a MSW supplied addon tool.

What you need to do is set up a classification higher than undetermined with a delivery action. Then change the re-classifier from clean to this higher one. Reason: you can not re-classify lower than the undetermined classification (or this is as I see it) By the way I use this for bad smtp...

Set up a route using the re-classifier with a classification set above undertermined with deliver action. classification is say, bad-smtp. Data types SMTP. On corrupt items detected choose your new classification bad-smtp Easy.

Interesting that the software knows 23 ports are working, but its not listed under the individual port info.

one of the ports has stopped working. When I do a sh ver the output is :- cisco WS-C2924-XL (PowerPC403GA) processor (revision 0x11) with 8192K/1024K byte s of memory. Processor board ID 0x0E, with hardware revision 0x01 Last reset from warm-reset Processor is running Standard Edition Software...

I have the same problem. Connections are lost and can not ping from a w2k workstation. I don't know why. We also use Intel pro 10/100 LAN cards on nt4. I am trying to see if its cabling problems. I have also been monitoring the following w2k performance logs: Conection Failures, Connection...

When I show diagnostic logs for a 2924M-XL the timestamp only shows the nearest day "11w0d". How do I set the log to show the complete time ? Also how do I get a more detailed error rather than "experiencing errors". Example line of log:- 11w0d: %LINK-4-ERROR: FastEthernet0/1...