Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by jke55

  1. jke55

    Feature code for activate/deactivate cfd on a 500 set on an Opt 11

    So if the cfwa code is *1, the cfwd is #1 and the spre is 1, then to activate I would have to dial 1*1 and the number and to deactivate I would dial 1#1???? Or just dial *1 and number - activate, and #1 - deactivate???? Please confirm. Thanks
  2. jke55

    Feature code for activate/deactivate cfd on a 500 set on an Opt 11

    What is the feature code to activate and deactivate call forward to an internal extension for a 500 analog set on an Option 11? Thanks!
  3. jke55

    Meridian 1 M2250 console

    Does anyone know how to add off-hook station indications(BLF?)on blank keys on a 2250 console? Keys 5-19 are blank keys.
  4. jke55

    CDR Setup on Opt 11C - via OTM

    Can someone please provide detailed steps on how to setup the Opt 11C for CDR? We have OTM and would like to be able to get the CDR data through the OTM. Thanks!
  5. jke55

    Meridian Mail OTM - cannot ping IP addresses

    We are attempting to setup OTM on an Opt 11C PBX. We have a static IP address connected to the PBX. We can ping the IP address of the PBX active ethernet link from the onsite network, connected to a Cisco switch, which is connected to our Corporate network in a different location, but we...
    • jke55
    • Thread
    • Replies: 0
    • Forum: CORBA
  6. jke55

    Avaya S8700 - BRI Lines for Video Conf on T556D circuit pack

    AT&T is the LD carrier. So, should we build a different route pattern for the ISDN calls. The existing route patterns that are for phone calls have ITC all rest.
  7. jke55

    Avaya S8700 - BRI Lines for Video Conf on T556D circuit pack

    Yes, SBC. We have other ISDN lines off of a Nortel PBX that we do not have any trouble with video conferencing out of the SBC PRI's. Does the config look correct on the BRI lines?
  8. jke55

    Avaya S8700 - BRI Lines for Video Conf on T556D circuit pack

    Someone please tell me how to program ISDN lines for h.320 video conferencing in the Avaya S8700. I programmed them as data modules with one DID number on link 1 and the 2nd DID on link 2 on each port on the T556D card. I don't see that I have 2B+D because I don't see the D channel portion for...
  9. jke55

    Avaya S8700-TN556D ISDN BRI cards and wiring

    When programming the lines I did an add station XXXX1 and set it up as a WCBRI. I added my second station XXXX2 for the second B channel, but it would not allow me to use the same endpoint id. I used 01 for Bchannel 1 and 02 for Bchannel 2. Am I programming this correctly? What will the SPIDS...
  10. jke55

    Avaya S8700-TN556D ISDN BRI cards and wiring

    Does anyone know how to wire and program the Avaya TN556D ISDN BRI cards for video conferencing? Our (3)existing BRI lines are off of a Nortel PBX and are 1 pair per line, 128K per line for 384K two way video conferencing. The Avaya documentation states that the BRI lines on the TN556D are 4...
  11. jke55

    Testing E&M card on Opt 11C

    Is there a way to test a 4W E&M card in the Option 11C remotely? LD 30?
  12. jke55

    Meridian Mail Access

    jelder@reliant.com
  13. jke55

    Meridian Mail Access

    How do I get the .kbd file?
  14. jke55

    Meridian Mail Access

    The F6 with Procomm Plus does not do anything.
  15. jke55

    Meridian Mail Access

    This applies to remote access, i.e., dialing in with Procomm Plus?
See more

Part and Inventory Search

Back
Top