Recent content by gferriott

Well this is the first time this system has ever been up, we are going to upgrade it for a while. The company I bought it from sent the Auth codes but not the Key codes. Then he tried to tell me that they were in the system and ready to go, but they are not. When you get these things they...

I have the authorization codes to get them from the site. You have to login to the site and then the site will generate the 24 digit Key Codes. The documentation I have has the "Authorization Number Label" on it but no code. Thanks, Glenn FCC Communications, Inc.

Can anyone help retrieve Key Codes from the KRS site and then I need the latest patches for the BCM 50 version 1.0 Thanks, Glenn FCC Communications, Inc.

Hey TL I have the same problem, ours is a BCM 50, Got the codes but can't get them from KRS site. Thanks, Glenn FCC Communications, Inc.

Thanks Phoneguy, that's alot better than getting a new card. I thought that pulling the board might cause it to boot slowly but did not think it would lock it up like it did. We had a test set on 221 which should be the alarm set but I have never seen this system running. They brought it from...

We pulled it out because the system was much larger and now its just a 6X12. I guess we did not have to pull the fiber expansion out. If we put it back do think that would sove the problem. Also we installed 2-analog CO modules. Thanks, Glenn FCC Communications, Inc.

We are installing a system from a customers former location and now they are straight analog. We pulled the T-1 and 6-port fiber card. Now the system just sits there and says its in Maintenance Mode. Someone suggested to open up the MICS and short the capacitors to do a hard reset. Does this...