Recent content by gbanke

Avayadude, Many thanks for the detailed configuration steps. Greatly appreciated! Gary <><

Has anybody configured the Lantronix UDS-10 device server to work with the Definity over the terminal port and then access with ASA? I have a Precidia on my Definity in Denver that works great. Can't seem to get the Lantronix unit to work though. Any help would be greatly appreciated! Thanks...

Thanks for the info. Kind regards, Gary <><

The agent names in DSM Wizard, for example, are not easy to decipher. Names such as CaiUxOs, for example, are somewhat obvious, but even then it's hard to know exactly what each agent is and it's scope. I wanted to find out if someone (or CA) has a document that details each agent. TIA, Gary <><

Does anybody know where I might find a list of Unicenter agents and their definitions? TIA, Gary <><

Dom, Thanks. That's the conclusion I've been coming to myself. I did manage to grab the CleverPath Portal Getting Started Guide, but that's it. We're on UC release 3.0 GenLevel 0211. I'm trying to understand if it's possible to extend the portal to prvide portlets for things like...

Does anyone know if CA has a technical document on the Management Portal? If so, can you post the link? Many thanks!

The biggest problem my predecessors had was with SNMP. My understanding is that CA has community strings hard-coded in the product which wreaks havoc when trying to alter the default 'public' password for managed objects. Certain admin procedures appear to overwrite localized community strings...

Forumers, I'm new to the Unicenter NSM product but have been certified and involved in OpenView for many years. As I begin down the Unicenter path I'd like to hear from the forum members regarding the pitfalls of deploying Unicenter, and how to best avoid them. My company has invested heavily...

Phoneman2, No, it's not the first T1 in my system. It's connected to a Cisco 3640 VWIC to provide IP voice calls. This is a pilot project, so I'm just using the TAC to make test calls. No AAR or route-pattern stuff is configured yet. I can complete a call just fine, but it dumps after 3...

Hi! I've just completed setting up a DS1 TN767E card with a 24 member trunk group. When I make a test call using the Trunk Access Code the call only stays up for 3 minutes then drops. It only happens when I initiate the call. I've reviewed the timeout values in the trunk group...

I'm working on a pilot project to get our internal voice traffic moving across our private ATM network. I've installed a TN767E, setup a trunk group with 10 members following Cisco's configuration documentation to the letter. I found information on this forum on how to pinout a Cat 5 from my...

Dimas, Your pinout information in this post was the ONLY place I found accurate information for connecting the PBX to a Cisco router. I know your post was directed at a CSU/DSU, but it worked for my router as well. Most helpful. Thanks! Gary <><

CL - That did the trick! Thank you very much for your prompt help. Much appreciated! Thanks again! Gary <><

I just added a new DS1 TN767E card to cabinet 1 in slot 12 on my G3. When I do a 'list config all' the card is displayed. I created a new trunk group for this card and am trying to add members to it. When I attempt to add member 01A1201 I get the message 'Must use administered DS1 or UDS1...