Recent content by forwardslash

I have had this happen a couple of time with differant end users. basically what I had to do is check and make sure that the email address they were sending the document to were correct. Hope this helps. M

Hello:) I need to change the primary key in the DB. Is the a way to do it without deleting the data. At this point it would not be a probelm since this is a new project. Any idea's anyone could give me would be great. Thanks Michele

Which program and version are you using? Michele P :)

I know you said that you copied the .dll file, but I found this link that may help you. http://support.microsoft.com/default.aspx?scid=kb;EN-US;q194455 I hope it help you. Michele P :)

Did you try to re-name the pst file? If not, then try doing that, this may enable you to then re-import the good ones. Then you should be able to delete the bad ones. I hope this helps. Michele P :)

Do you have a lot of application running and how is your memory? Michele P :)

Do you have a lot of apllication running and how is your memory? Michele P :)

Do you mean that you would like to print a section and then add to it later? If so, I know this seems like a lot but you may want to try to change the top margin before you print the next section or you can cut and paste to new word doc and continue to add as needed. I hope this help:)...

I'm assuming that you are on a network. Try setting up a folder marked "Updates" in a place that everyone has access to. Then place the new font in that location and send an email instructing employee's how to find and install the font. Hope this helps:) Michele P

I don't know if this will help you, but in tools/options there should be a section that should send/receiving messages. Try unchecking the box and closing out of outlook completely and then reopen. sometime you have to fully leave the progam betfore changes take effect. I hope this helps...

Hello. I also have been this same problem. I may have found your answer and mine on a site that I found. I have not testd this theory to see if it work yet, so I don't know if this your answer. CAUSE This behavior can occur if any of the following conditions are true: - Data Access...

Help!!!! In certain programs I am running, I'm getting the error message "ActiveX component can't create object". Does this mean that ActiveX has been removed from my PC? Can anyone help? Thanks. Michele P forwardslash@email.com

I'm always working I'll send you that file in a little while. Thanks, Michele

Yes, it would be a new entry line. What it is doing is when you go to that line it only show that current lines info. It doesn't do the complete running totals, from previous entery's plue current ones. I would send you a print screen, but I don't think I can do it frm here. I hope this...

The calculation did work, but what is happening when I tab to the next entry line the calculations disappear on the top portion of the form . Is there a way to keep the totals running and show an accurate count? Thanks, Michele