Recent content by DblDown

Why not pass all the attendent calls trought a vdn and vector then report on the vdn or vec through BCMS or CMS? Am I missing something..?

Other the rout patternes where do you tell the PBX what area code its in.. it use to be in the "cha dial" but this is a Ver 8 box and its not there .. any one know???

Ok the pbx let me add a DataMods for the new positions withoud a pysical boards.. Another question is I only have /had one Announcement Datamod entry for the two cards is that normal?.. it been working that way for years.. I asume that for moving both cards I need to have a datamode entry for...

Thanks.. One more question.. I currently have two boards both with "data" is it posible to change them by swapping whith the steps above and not lose there annoucments.. I guess what im asking does useing the board to register the data mod mess with the data saved in the flash.. Trying to advoid...

Does any one know if you can move a TN750c (Announcment) to a diff slot without loseing any "data". I need to consolodate a cabinet but I don't want to re-record everything.. V7 G3si..

Thanks for the Info guys...

Need to send a customer service call from a basic VDN/VEC auto attendent to a call center via (route to) a toll free number and I need to pass the callers ID/ANI, not My PBX INFO, Anyone know a simple way.. VER7 G3, Vectoring and call center basic..

I Trying to figure out how *ani*dnis* or ani*dnis From an inbound LD trunk->udptable->Confrerence Trunk group->confbridge looking for *ani*dinis*..I guess my question is how do I send *ani*dnis* out a trunk group (G3si V7)..And info on how the Definity treats in and out ani/dnis would be...

I have a PBX in NYC with the same Problem 9xxx Are the DIDs and I use ICHT to Convert. So my employess internal EXT are 6xxx and there DID is 9xxx. I simply Del the 1 digit and add the 6, it works well. 1.(service/feature) match the sevice type on page )0ne 2. (call len) I asume are (4)...

ANYWAY AFTER GOING THROUGH JUST ABOUT EVERTHING I COULD THINK OF IT ENDED UP BEING "DISCONNCET SUPERVISTION IN = Y" IN THE VOIP TRUNKGROUP.. THANKS FOR THE HELP ANYWAY. Here is the expalnation "if you care" , MY VOIP TRUNKS HAD NO SUPERISION. DAMN KIDS Thanks again...

What VER# or ADMIN RIGHTS do you need for this command ? This PBX is VER 7.xx..

I'm have some routing problems between voip gateways when trying to TAIL end Hop. The situation is this, office(A) calls an assigned 4 digit EXT (ARS) to OFFICE(B) (VIA)->Rout pattern->(ISDN TIE) TRUNK GROUP->VOIPGATEWAY(A) ---Dedicated bandwidth-- to ->VOIPGATEWAY(B)->PrologicTRUNK GROUP(b)->...