Recent content by crh15

I am currently able to forward calls off-campus, but I would like to see if there is a way to forward calls internationally. Please advise. Thank you.

I have setup a new Vlan, vlan propogates throughout the network equipment, I have set up a few ports to access this new vlan but the end devices cannot see each other. Please advise.

Thank you, this worked exactly how I needed it to. Thanks again

Just got a Cisco 851 router, and I inadvertently erased the startup config. I need toget back to it's "out-of-the box" original config. 'write erase' command did not get me back. Please advise Thank you

It looks like the issue was a loop left in by Telco. After the loop was removed and the circuit was normalized the connection came up. Thanks to all for the help.

still no connection framing and linecode do not have the correct options for esf & b8zs

Thanks again, I'll give this a go as soon as I can, and update. Thanks for the help.

Thanks for the help, please let me know if I will have to have the same E1 card on the US side? Also, any suggestions on the config would help. Thanks again.

The delivered line is an E-1 on the UK side. I hate to ask the question, but do I need to have a different card on the UK router (other than a WIC-DSU-T1-V2)? If so, which card and how do I configure? Thank you

I am trying to configure 2 Cisco routers between the US and the UK. Simple router config for point-to-point use, using WIC DSU T1 V2 Serial Interface cards. Works fine in the US, but I cannot get them to talk to each other across the pond. It has been made mention that there might have to be a...