Recent content by completenoob

On the computer and LinkSys, you probably don't want 192.169.x.x, but rather 192.168.x.x... Burt" Ups..., completely screwed it up there....it is 192.168.x.x Thanks Burt Again, corrected version: Thanks everybody for all the info and help troubleshooting this problem! I managed to set it...

Thanks everybody for all the info and help troubleshooting this problem! I managed to set it up :) For orher suffering souls that might run into the exact same problem here is a short walktrough for setting up: equipment used : cisco 851 router, Linksys d-link router, cable modem, pc winXP...

So... I used the console cable and Hyperterminal to connect. It connected and gave me the VIDEOTRON LTEE acess forbiden enter password lines. Password cisco did not work :P Since it does seem to be preconfigured I called their support line and got my static ip, subnet and gateway address from...

I have entered 10.10.10 2 into ip and 255.255.255.0 into tcp ip settings for lan connection and the "limited or no connectivity yellow triangle dissapeared. I guess its a good sign. (after initial frustration for not being able to get this up and running i have pressed the "reset" button on the...

The cable is a "4 pairs patch cable" ipconfig says that "autoconfiguration ip address is 169.254.69.165" "subnet mask 255.255.0.0

Thank you for all your replies! I am planing to make this domain public, so i guess I will have to setup the cisco router. I had some spare cables and have made a console cable using instuctions from >http://www.dslreports.com/faq/9857 It is ready for action. I do not have Norton but Zone Alarm...

Hi everybody, I need some serious advice regarding what I should do. My plan is to use my computer to host a small business website. I have cable modem and linksys d-link router. I found a way to set it up (with help of a few website tutorials) for routing traffic to my website, but my isp...