Recent content by CaperJ

6500 works on dnic integration with a sx 200

Sys id is on the control resource card when booted go into form dimension and system select

sx2000

Thank you for the reply I found it about an hour later

Cannot disable Auto-PVID use command no auto-pvid get an error cannot disable pvid switch is factory default

Use genesis buygenesis.com

On newer 200 rel 3 and later make sure that in the pri trunk descriptor QSIG Supplementary Services are are disabled it is on by default. with this enabled you will not be able to forward.

COS option 208 in trunks and set COS option 245 in set system option 21 (form 4)

Yes when you setup your nsy choose network side interface on the main screen and Network side in link characteristics

Try turning display held caller ID on transfer to no in the set and the trunks

COS auto camp on timer on trunks and the set blank it out. Do not put o as this means indefinite camp on.

If 7.1 there is an issue with how memory is accessed in this release. You can either upgrade to the latest 7.1 with SP or go to release 8 the issue is resolved.

I have networked dozens of SX2000 and 3300 systems. Although it is easier to have a uniform dialing plan it is definitely not required. Opsman will ensure the dialing plan works. Keep your cluster element ID's the same length as the extensions. Keeping the numbers unique only allows you to...

There was a load of software that when upgrading you had to not choose restore dimensions, use new dimensions or you run into all kinds of issues

make sure you have a copy of your imat db or you know your settings as the below steps format the card for the new release Get the 8.x release from MOL and extract the files that are in the zip to a folder on your C drive such as temp you will see a folder called PRI_INSTALL open that folder...