Recent content by CanGoalie

thread798-1611602 We are having problems with a new CS1000E system at release 6.0. Two MGU cards have gone bad in less than 3 months. All FAN LED's are flashing red and green. Does anyone know of a know problem for these. I have referenced a thread from July 2010 from another user but there...

Thanks, I appreciate you taking the time to reply. Don

Have you found a solution to your problem? I am experiencing the same. Let me know if you can. Thanks Don

We have corruption on three TN's at the moment. ACD agents / Supervisor were moved using MOV, ECH etc... I know it is not the way to do it but the tech was not aware. The TN's in question show that they have a supervisor. Cannot remove the agent or delete the TN. Problem is the key they...

Call Pilot 1005r Release 5.0 SU 8 If I access our Call Pilot through a PRI from another switch on campus (direct fibre), it does not let me log in to my mailbox. Seems like it does not recognise the DTMF tones. I enter the mailbox number then #. It asks me for a password which I enter and then...

Thanks for the reply. I agree it would not make sense for it to work. Just a note though, my three card system is running release 13. Thanks

I have a card option (3 cards) that has an issue after a power failure. Question I have is: Can I replace this setup with a single card Meridian mail ? Thanks

Is there a way to disable the DTMF when a user is entering the password? Call Pilot 5.0 Meridian Mail did not.

I am at release 5.0 and am looking at this exact problem. Didi you use biv343's suggestion? I have done the dosFsShow /d command but want to be sure before I attempt the cbioRdyChgdSet command. Has anyone done this successfully on a 5.0 system? Thanks. If biv343 is available, can you...

thread798-1592416 CS1000 MG Release 5.0 / TM 4.0 When acessing the troubleshooting tab for a particular set, I get the TBUG632 message instead of IDLE or BUSY. Noticed that it does not do it for older systems 25.40B or on a particular release 5.0 system without a DEP list installed. Any...

Your statement: OK--Since Verizon said we were sending CallerID I went ahead with our contractor and set HLCL to 254-3729 and ESA_apdn to yes. I then called a number and did the TRAC. It is showing our calling number to be 202-254-3729. I can only assume from this that Verizon is sending the...

Just to update: The problem was really narrowed down when the power supply smoked in the switch. (11C) I was surprised since SYS809 did not seem to point to power. Thanks for the replies

Thank you, I will try these prints in PDT.

Good morning, Running an Option 11C at Rls 25.40B The unit performed a SYSLOAD and I am trying to determine the cause. Have not seen 000809 in posts before. The switch also did not come up clean as I had to get two TMDI cards hard reset in order to be able to send enable commands to them...

If it does not come up, try in LD 48 ENL AML (your number) ACMS