Recent content by beshkey

Hi all Could someone help me as every time I try to run long reports or even just to list stations my system locks it self. I am connected via a lan connection. the error messsage is: General communications error A communications-related error has been detected and reported by your...

Hi We have a couple of Index systems linked to a Definity via Qsig. The Index are connected via dpnss, one of the INDeX's is qsig'd to the definity . We get a really wierd problem when transferring calls From the Index to the Definty. So INDEX 1 has a QSIG link ( to DEFINITY), DPNSS to...

Hi Can someone please go through the commonds as to how to setup a user on the index system, Many thanks

Hi all Can someone explane as to what Alphanumeric-dial-table is and what it is used for Please?

Hi On the extension number were you have display st 4513. you need to change Per station CPN - Send calling number to (n) NO.This is on page 2 on the right hand side I think that this will work.

You can delete it once you are on the speed dial screen. It gives you the option to Add, Edit, Delete and Done.

Hi all Does anyone know how to program a basic rate card please?

Hi you need to access you outgoing trunk and on page 3 you need to change the Send Calling Number to yes. Hope it works for you. Beshkey

Hi, Ok, here is a question that has been a pain in my back, so if anyone can help I will be inedited to you. We have two CMS systems (one backup) that are based in UK which is dedicated to on of our sites in Europe. The problem that we face is that once in a while the CMS server starts to...

Hi all, Could some one please explain in lame terms as to what MPLS means? Many thanks

Could anyone out there know what a T1 is please. Many thanks

Hi, Try this link it will give you all the info for the programming of the 2402. http://esearch.avaya.com/r/results.asp?SITE=com&querytext=2402+phone Have fun :)

Hi, At one of my sites we have h1 for voice mail in the cover path. for one of my users in the same site we have h1351. Could you please tell me what the command is to find out were h1351 goes to. Kind regards, Beshkey

I have a major problem where I use a S8700 G3XV13 system and for no apparent reason when I do disp capacity on the system it showed that I am using 54658 IP Softphones where i am only licenced for 370. as shown below Logged-In IP Softphone Agents: 54685 0 370 Logged-In IP...

Hi I think you need to change ip-codec-set 1 ( which ever the set may be ) and change the silence suppression to N and change the setting on the pacet size to 20. it might work Beshkey