Recent content by alarmcallpending

OK, we ordered a new one, thank for all the help Sir.

did everything you stated including replacing the drive. On start Status goes yellow and stays yellow, drive (both original and replacement) do not spool up. Hyperterm to serial port on bootup shows nothing, does not repond to any typing.

It is a C17A49 and I see the three pins near the cap. These pins are near the edge connector with no jumpers. thanks

I have a Merlin Messaging module that the status light stays yellow. In looking at the board itself, I noticed a bank of four sets of pins for possible jumpers located near the back of the module. There are no jumpers on any of the pins. Could this be the problem? thanks

Is there a common default admin mailbox password to allow me to program the system? thanks

Any way to route a call coming from a T1 connected to a merlin Legend (as a outbound trunk) to any avialable member of a trunk in a definity PBX? thanks

right side up, we have checked the pins about 100 times it seems. We got an Avaya tech in about an hour, thanks for all of your help ppl.

Done that about 10 times already. Test 572 fails with 2003 indicates too many errors on the bus for the maintenance pack to correct AND bus has three leads faulted not open.

removed carrier c. Now have major packet bus alarms. checked all pins, all look good. Shut down carrier b, alarms go away. power up carrier b with all cards pulled. OK. On inserting the TN577 Packet gateway major Packet bus alarms appear. Any ideas?

Sysytem Capacity book indicates 99 is the max for a csi. The R6r max is 600.

Can you connect a Merlin to a definity switch via a T1 and use the definity trunks for inbound and outbound access? thanks

Below is a part of the extension directory report. Is there a way to tell if I have 5 available ports for some new stations? I am thinking the 7xxx station might be available. Do all ports automatically get assigned to dummy stations? thanks 14/ 3 511 RM 511 N N N N U 3 N 14/ 4 512...

Problem resolved. Unclear as to fix but probably either Time in Queue changed to 0 instead of 20, or earlier admin change & site (remote) has finally tested properly. Thanks for assistance & good luck.

Don't know about after 20 secs. Time in Queue setting overrides Calls in Queue Warning setting (1)? In any case, I'm testing with 0 instead of 20 secs. Inbnd trks destination is 'attd', not the attnd ext. Console Type is 'principal' for Attendant 1. An Attendant 2 (that I don't know what it...

I have a v6 Definity with 302C attnd console. Can't get Attendant Backup Alerting to work. Trying to force 2nd inbnd call to attnd console to go to backup positions- 5 different 8410Ds. Calls in Que Warning set to 1. Backup Alerting toggled y. Time in Queue at 20 sec. Incoming Destination...