Recent content by 2gordo

Thank you for the responding. This is a real pain.I have tried to busy/rel the systemem tells me the port does not exist. I try to assign it to a station the system says it has already been assigned. I display port the system says the port is assigned.I have unassigned it from t to u on the...

I need a fix for analog ports that in the li conf screen show "t" but can not be assigned to a station. I X-ported before I busied the analog station. Now when assigning the port to a station you get an error message, that the port has already been assigned. IDEAS?????

It sounds like your ars table is blocking the call. With all the new prefixs for cell phones you might check the partitions and make sure the prefixs are listed. You can use "disp ars analysis partition 1 xxx" to check for your prefix.

Thank you Tina, That is a great long term solution. Thanks again. 2

Thanks CL, I am able to use the console permisions with limitations. What I am looking for is remote access programming information. 2

I manage a large number of Definity and G3, G3si's. The problem is that users and unauthoried users are call-fwding phone and soft numbers. Is there anyway to remove the fwd to save having to dispatch a tech to rmv it? 2gordo

Frankieg and Bobg1 thank you for the help. This is my first time using Tek-Tips and won't be the last. Thanks again 2gordo

I am out of card slots and analog ports on my Definity Cabinet. When I roll theTN746B with TN793B the card goes into Major alarm and in the li conf it says I have a conflict. Can someone please provide me with the proper proceedure for changing out a TN746B 16 port Analog card with a TN793B 24...