Recent content by 104addo

I think the problem may be a bit more deep rooted as I've unplugged the SATA disks from the RAID controller and plugged them into the main system board. The disks can be seen now but Windows Setup brings up an error with the following code (0x4 0x1, 0, 0)! I may have to go back to the suppplier...

Hi itsp1965! I did try F6 during setup but it seemed to carry on. IF I do "break" into it, do I use the HP Proliant ML110G2 Server support CD, supplied with the box?? This includes Drivers. I know Smartstart is no good for these ML110 which is a pity.

Hi I have a recently had delievered an ML110 server with 4 SATA disks.I've installed all the disks and created an Array but set it to just Volume as I don't want any Raid Levels setting on these disks. I've booted up off my Win2k Server CD, but Windows can't see the disks even though the array...

If you try the the GUI.. 1. Open policy 2. Double Click client 3. Highlight client name 4. Click Delete button.. Is it at that point you get the "exceed limit" prompt?

Hi Stumpr and other interested parties! I tried your suggestions 1 and 2. The settings for the tcp_xmit_hiwat were set at 24576 so there appeared to be no issue there. I did suggestion 2 and I got back successful results. I created an admin directory under /usr/openv/netbackup/logs and re-ran...

Thanks for the info. I shall go through these and I'll check out the size of the Catalog as well!!!!

Hi Currently we have a Netbackup 4.5 server (Solaris Platform). I've configured the Catalog to back up to disk one evening and to tape another evening. The Catalog backup to tape appears to "hang" and displays as still ACTIVE after my backups have finished. The catalog size is approx 650 mb...

We have had a major system fault relating to MEMFS on a SCO Unixware 7.1.3 Server. Using the SCO support site we have attempted to run an idtune to change a couple of tunable parameters but we are now getting serious errors whenever we try and run commands such as man etc. EG. man idbuild...

Dear All, We have A SCO Unixware 7.1.3 server with a runaway lpsched process which kills the system. I can do an lpshut and lpsched and all runs fine for a day or two then returns to haunt us. Should we have any specific patches or a specfic fix for this? Regards 104addo

Hi I'm busy providing documentation on some SUN Solaris servers and need to print Netbackup and Legato screens out. Apart from Kea X are there any other products out there I can install on my client to connect to Unix servers and print screens out locally. Many thanks