Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
How to attach a word document at the last page in Crystal 8
- Thread starter fredong
- Start date
synapsevampire
Programmer
In response to your other post, place it in the report footer, not the page footer, and turn on the New Page Before.
-k
-k
- Thread starter
- #3
I did turn on the page before in format section.However, after I inserted the word document on the Report footer and preview it, and it showed only quarter of the word doucment and I tried to pull it down to expand it and the entire word document went away.Remember I have vertical lines across the report footer. let me know ..if you have more ideas. Thanks.
synapsevampire
Programmer
Why do you have vertical lines?
Perhaps you can right click the report footer and select insert section below and place either the lines or the doc in a seperate report footer section?
-k
Perhaps you can right click the report footer and select insert section below and place either the lines or the doc in a seperate report footer section?
-k
- Thread starter
- #5
I made a mistakes this is not what I wanted to put in the report footer because the I have quite a number of information on the page header and the 1 page word doument has spanned over 3 pages after I had printed this is because the page header has taken 1/4 of the page. What I need is an attachment of a 1 page word document after the last page invoice. Any ideas? Thanks.
synapsevampire
Programmer
Just suppress the page header on the last page using a suppression formula of:
onlastrecord
-k
onlastrecord
-k
- Thread starter
- #7
synapsevampire
Programmer
It is onlastrecord using crystal syntax.
Right click the page header section and select format section and click the X 2 next to suppress and place it in there.
-k
Right click the page header section and select format section and click the X 2 next to suppress and place it in there.
-k
- Thread starter
- #9
- Status
Similar threads
- Locked
- Question
- Locked
- Question