×
INTELLIGENT WORK FORUMS
FOR COMPUTER PROFESSIONALS

Log In

Come Join Us!

Are you a
Computer / IT professional?
Join Tek-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!
  • Students Click Here

*Tek-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

Share UPS AP9207

Share UPS AP9207

Share UPS AP9207

(OP)
I setup AP9207 share ups to multiple shut down 4 servers. I installed Powershute 5.2.1 and used correct the cables either on Advanced port or basic port. But I cannot see all 4 servers on the Powershut program only two of them show up.
Please help and thanks.

RE: Share UPS AP9207

By any chance are the other 2 servers on a different network?  If so, there's your problem.

Either way, can you manually enter the server's netbios name in the server name box to connect to these servers?

RE: Share UPS AP9207

(OP)
Yes, all servers are on the same network and can communicate each other either by IP or by netbois name. The NetBEUI is installed also.

RE: Share UPS AP9207

When you installed the PowerChute software, did you install it on ALL servers?  If not, that's what you need to do.  Also, make sure you configure the software correctly.  For servers on BASIC signaling ports (#s 2 thru 8), you need to select BACK-UPS with SIMPLE signaling even though you may be using a SMART-UPS.  On the advanced port (port 1), you would select SMART signaling and the actual UPS type (SMART-UPS, BACK-UPS, etc).

When you said you can communicate with the servers via IP or NETBIOS, were you talking about via the PowerChute software or network neighborhood?

RE: Share UPS AP9207

(OP)
I did all your suggestions above. And each server can make the communication with UPS. communication between servers is not via the PowerChute software. All setup and configuration is correct and I talke the APC support, they cannot figure it out. Thanks.

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Tek-Tips Forums free from inappropriate posts.
The Tek-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Tek-Tips forums is a member-only feature.

Click Here to join Tek-Tips and talk with other members! Already a Member? Login

Close Box

Join Tek-Tips® Today!

Join your peers on the Internet's largest technical computer professional community.
It's easy to join and it's free.

Here's Why Members Love Tek-Tips Forums:

Register now while it's still free!

Already a member? Close this window and log in.

Join Us             Close