NEC2400 Hunt Groups - IMXMAT

iBrokeIt · Dec 17, 2004

I need to change the extensions in a hunt group ...I have the manuals (NEC2400)and the software installed OK, but do not have a clue where to begin looking.

How to I "get" an exisiting hunt group- to at least view the members?

Any help - directions - suggestions - are most welcome.

CDRMAN · Dec 17, 2004

If you know an extension in the hunt group you can do a DSTN and the keys below will allow you to see what kind of hunt group it is in, but also what the other extensions are.
Circular, Pilot UCD

LSHC , LSHP , LSHU will list out extensions in all hunt groups , depending on what is assigned

Warning make sure you know all the extensions in the hunt group , If you delete a group , you will not be able to see what was in programming.

iBrokeIt · Dec 20, 2004

Thank you so much for the direction ... with your help I can get about 6 nursing staff off my back

I will use your info and the manuals to get this working - and credit will be given to your help! Thanks again.

Chuck

CDRMAN · Dec 20, 2004

No thanks needed just doing my part to help

Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

NEC2400 Hunt Groups - IMXMAT

iBrokeIt

MIS

CDRMAN

IS-IT--Management

iBrokeIt

MIS

CDRMAN

IS-IT--Management

Similar threads

Part and Inventory Search

Sponsor