Directory command: Display and no display
Directory command: Display and no display
(OP)
I know there's a directory command in ld 117 that identifies how many digital sets(eg, M2616 and M2008 telsets) that have been configured, as well as the telset part number, but was wondering if there's a directory command that identifies/inventories how many these digital sets have a lcd display, as well as ones without display? Any info on this would be much appreciated.
Sincerely,
kuser
Sincerely,
kuser
RE: Directory command: Display and no display
LD 81
REQ CNT
CUST 0
DATE
PAGE
DES
FEAT SETS
FEAT CUST TOTAL SL1 500 2500 4020 3000 2000
SETS 00 CNT 7 4 0 2 0 0 1
It should come out looking something like that. You can also specify SET type (2000, 2008, 2616, 3000, 3904, 3903, 3902, 500, SL1 etc)
LD 81 also has a LST (list) command. It's entered the same way as CNT using the same set of responses to FEAT.
If you're truly looking for the LD 117 response, I believe you can generate a list (inventory) of sets by using the following:
LD 117
=> INV GENERATE SETS
Upon getting the inventory generation complete message:
=> INV PRT SETS
You can also use: => INV GENERATE CARDS and =>INV PRT CARDS to get an inventory of all the cards in your switch.
Hope that helps!
-Archie
RE: Directory command: Display and no display
Again, sorry about the long-winded first post. Can anybody tell me how to remove my posts which I put up in error?
Thanks,
-Archie