×
INTELLIGENT WORK FORUMS
FOR COMPUTER PROFESSIONALS

Log In

Come Join Us!

Are you a
Computer / IT professional?
Join Tek-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!
  • Students Click Here

*Tek-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

Ipoffice constant rebooting

Ipoffice constant rebooting

Ipoffice constant rebooting

(OP)
Hello,

Our Ipoffice 406 goes in constant reboot by unknown cause.

Today it holds in permanent reboot, and the message below appears
in the console:  "VCOMPPCB: Warning failed to load code".

The constant rebooting happens also if the Ipoffice is disconnected
from the Lan and the E1 cable link.

I made a configuration clean to the default configuration, using the procedure at the console, and a reload from a configuration backup, but it not fix the trouble.

Power down/up all the modules produce a normal operation, for some
time before the next reset.


The IPO has software 1.4.25.

Any help will be appreciated.

Thanks,

Gustavo.


RE: Ipoffice constant rebooting

Try removing the VCM , then power up, have seen several VCM cards go bad

RE: Ipoffice constant rebooting

Does the unit behave in default (AT-X2, AT-X3 from dte port)
if so then the problem is with your config.
usualy this is caused by creating a loop with IP routes.

RE: Ipoffice constant rebooting

Re-write the config from a blank config and see if this works.

RE: Ipoffice constant rebooting

(OP)

Does mean that the VCM card has a hardware failure ?

This can cause that the IPO restart and it can't startup
some times and in this cases it need a power down/up for a good startup ?


Thanks for the colaboration.


RE: Ipoffice constant rebooting

Dont re write the config toooo much work, just run the wizard in V2, will pick up most errors.

Have seen several sites where when the vcm is installed the unit will not boot, all lights on front panel, removed the vcm and unit boots ok

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Tek-Tips Forums free from inappropriate posts.
The Tek-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Tek-Tips forums is a member-only feature.

Click Here to join Tek-Tips and talk with other members! Already a Member? Login

Close Box

Join Tek-Tips® Today!

Join your peers on the Internet's largest technical computer professional community.
It's easy to join and it's free.

Here's Why Members Love Tek-Tips Forums:

Register now while it's still free!

Already a member? Close this window and log in.

Join Us             Close