×
INTELLIGENT WORK FORUMS
FOR COMPUTER PROFESSIONALS

Contact US

Log In

Come Join Us!

Are you a
Computer / IT professional?
Join Tek-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!

*Tek-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

Can not get into prgram mode

Can not get into prgram mode

Can not get into prgram mode

(OP)
I am working on a Panasonic KX-TA1232 PBX with a KX-T7030 phone-set.

Our PBX lost its programming.

I am trying to program our CO trunks.

When I pick up the phone I have on dial-tone even if I select a CO line.

The display reads Ven Jan 09 4:37P

I have two buttons with red lights on them FWD/DND and the message.


I have tried to get into the program mode with or with the handset down, with or with out the phone program button switch on the back and with or without using the pause/program button. I dial *,#,1234.


The display does not change.


I can put an analog line on the jack and I will get dial-tone after a few beeps. I can not dial out.

I get dial tone weather the CO trunks are plugged in or not.

I have tested the CO trunks with an analog set and they have dial-tone.

I have tried power cycling the unit.

I have tried pushing the reset button.

The station cabled are connecting to a Telco cable and terminated on a RJ66 block.

I have tried programming from every jack using a cross connect wire and biscuit box using a 4 wire plug to the jack on pairs 12 and 56 which comes up with a display.


Any ideas on what else to test or am I doing something wrong?

Is there a way to reset the password??

Is there away to test the unit to make sure it did not get fired?



RE: Can not get into prgram mode

Disp. Phone should be attached to PROGRAMMING PORT # 1 or
Manager Port Defined by System. @ This phone, Switch to
PROGRAM the Dial *#1234. At this point U shold be in
Programming Mode. If NOT, Then Password has been CHANGED.
Then INITILIASE SYSTEM.
@ KSU, Turn OFF Power
       Move Program S/W to PROGRAM
       Turn Power ON, Wait untill POWER Light Blinking
       Press RESET Button, Wait Untill Power light Blinks
       Move S/W back.
 At this point, From Port # 1, U will be able to get in to programming. If not then BAD KSU!

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Tek-Tips Forums free from inappropriate posts.
The Tek-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Tek-Tips forums is a member-only feature.

Click Here to join Tek-Tips and talk with other members! Already a Member? Login

Close Box

Join Tek-Tips® Today!

Join your peers on the Internet's largest technical computer professional community.
It's easy to join and it's free.

Here's Why Members Love Tek-Tips Forums:

Register now while it's still free!

Already a member? Close this window and log in.

Join Us             Close