×
INTELLIGENT WORK FORUMS
FOR COMPUTER PROFESSIONALS

Log In

Come Join Us!

Are you a
Computer / IT professional?
Join Tek-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!

*Tek-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

Problems with ISDN30 Channels

Problems with ISDN30 Channels

Problems with ISDN30 Channels

(OP)
Hi,

I hope someone out there can shed some light on the following problem.

We are using IP Office and have one ISDN30 connected to the system.

However, for no apparrent reason the system shows the ISDN channels reducing from 30 to 20 then 10 and there fore not allowing external calls and more importantly restricting incoming.

Disconnecting the switch seasm to clear down this problem but then a few days later the same thing starts happening.

Has anybody encountered a similar problem?

Many thanks for any help offered

RE: Problems with ISDN30 Channels

Maje sre that CRC checking is set correctly (usualy enabled in uk) then report this as a fault to your network provider.

Do not accept any "fobbing off" to check your system in ofer 3 years of alchemy I IPOffice maintanence (over 400 sites) we have never had an isdn card failure

RE: Problems with ISDN30 Channels

The problem is because the E911 setting is enabled depsite the Locale being set to ENG. What you need to do is:

- set the Locale to ENU and send the config;

- Open the E911 System Configuration and under System Parameters ensure Enable E911 System is NOT ticked. (you will see that the E911 icon change from red to grey with a tick).

- Send the config.

- Set the Locale back to Eng and the send the config.

This will resolve the problem.

It is caused by dialling the numbers starting with 911. Either the IPO is set for 9 prefix or they dial numbers starting with 911. With E911 set the IPO trys to Dial Emergancy to 911 and attmepts each channel, locking up each channel as it tries. This can be seen b running a monitor trace.

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Tek-Tips Forums free from inappropriate posts.
The Tek-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Tek-Tips forums is a member-only feature.

Click Here to join Tek-Tips and talk with other members! Already a Member? Login

Close Box

Join Tek-Tips® Today!

Join your peers on the Internet's largest technical computer professional community.
It's easy to join and it's free.

Here's Why Members Love Tek-Tips Forums:

Register now while it's still free!

Already a member? Close this window and log in.

Join Us             Close