Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
conver PDM powerdesigner to visio
- Thread starter TSuresh
- Start date
- Thread starter
- #3
Jay,
Thanks for the response. Jay, is there any way we can use mata data of the s-designer and conver it to VISIO data model. I hope there are some tools on the net. One tool I have seen is Model Bridge.
I am actually convering PDM from Powerdesigner 6.1 to VISIO. The best way I could find till now is VISIO reversing engineering. Do you think there is any other way of doing it better.
reg
-S
Thanks for the response. Jay, is there any way we can use mata data of the s-designer and conver it to VISIO data model. I hope there are some tools on the net. One tool I have seen is Model Bridge.
I am actually convering PDM from Powerdesigner 6.1 to VISIO. The best way I could find till now is VISIO reversing engineering. Do you think there is any other way of doing it better.
reg
-S
MetaIntegration can do it, from the newer versions at least. But you will pay for the privelidge $5K. Visio does not have strict models, that is they can be anything , weakly typed I guess. So the question is what sort of Visio models they would create.
To convert PowerDesigner models manually would take quite a lot of work. Especially as the 6 models were not XML. If you have a lot of metadata it might be worth paying for the conversion.
Easier to upgrade to PD 9.5
J
To convert PowerDesigner models manually would take quite a lot of work. Especially as the 6 models were not XML. If you have a lot of metadata it might be worth paying for the conversion.
Easier to upgrade to PD 9.5
J
- Status
Similar threads
- Locked
- Question
- Locked
- Question