Request is not active Request is not active riksweeney (Programmer) (OP) 21 Mar 03 07:01 Sometimes, but not always, when I'm navigating to a page created in the Page Designer I get a blank page. A couple of page refreshes brings up the following:com.sssw.rt.util.AgoApplicationExceptionProgramming error: request is not active.Has anyone ever encountered this? It seems to be limited to certain architectures RE: Request is not active annlieu (Programmer) 28 Mar 03 07:00 Normally we get the blank page when there is some exception thrown by some error in the codes (in PageGenerateBegin() or PageRequestBegin()). Perhaps you can use the try-catch block to find out why? RE: Request is not active mingus (Programmer) 1 May 03 04:57 I get that message on and off. I trap and send myself e-mail every time it happens. Always on the same page, and that page is using SSL. Page works about 8,000 times per every time it fails so I don't think it's the code but SilverStream. Never figured it out, never had SilverStream get back to me when I asked them.