I have recently upgraded a MICS to 5.0 XC software and enabled PRI on the system. I would appreciate help in the programming aspect of the T1. I not sure if I have it programmed correctly. On the T1 card what lights should be lit. According to the alarm I received there is a problem with the carroers side ot the T1. Any help on this would be greatly appreciated. Thank you.
Red Flag Submitted
Thank you for helping keep Tek-Tips Forums free from inappropriate posts. The Tek-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Tek-Tips forums is a member-only feature.